A Complete Range Of Metal Cleaning
And Surface Treatment Solutions

Telephone: +44 (0) 20 8281 6370
contact
 
 
   
 
  Click here to request
more information or an MSDS
CORREX HOME Arrow SUPER CORR A: CORROSION PROTECTION SPRAY Arrow APPLICATION METHODS

Application methods

SuperCORR A Can

A Lubricates And Protects From One Can

Arrow

SuperCORR will eliminate premature failure of components created by moisture, general or fretting corrosion. Reliability is increased and manufacturers can save costly warranty service calls or product re-call.

Arrow

SuperCORR Acan be applied using our 16 ounce, 12 ounce net, aerosol can with or with out the provided extension tube provided used for pin point accuracy or for those hard to reach areas. Shake aerosol cans before using.

Arrow

Can also be applied using a brush, sponge, or by dipping a component or part into a container of SuperCORR A. Stir bulk material while applying and cover container when not in use.

Arrow

This product can be applied during or at the end of production, during preventative maintenance inspections, or when a new component is installed. Shake or mix while applying, depending if aerosol or bulk is being used. Use extension nozzles provided with aerosol cans to access hard to reach areas.

Arrow

Components should be free of oils, flux and other surface contaminants prior to application of
SuperCORR A. It is recommended that a high-purity contact cleaner that cleans, dries and leaves no residue such as EnSolv be used to remove soils. If, after the component is properly cleaned, there is visual evidence of corrosion damage, it may be necessary to replace the component.

ArrowSuperCORR A is not designed to remove corrosion. It will clean and revitalise an intermittent connector but cannot replace damaged areas.

Arrow

For Aerosol applications apply material for a uniform coverage of the component from a distance of 8 to 12 inches (20 to 30 cms), including pins and receptacles. Over sprays can be removed with a precision cleaning solvent compatible with the component substrate or part being cleaned, such as EnSolv precision cleaning solvent. Two applications (coats) 30 seconds apart can be applied if required. Re-application should be performed as needed.


NOTE

SuperCORR Ais non-reactive to most plastics, however, do not use on Styrene or Polystyrene. Mask clear plastic surfaces (windows, ports, etc) before applying to prevent possible fogging or cracking caused by the solvent carrier.

IMPORTANT

SuperCORR Ais non-reactive to most plastics BUT do not use on Styrene or Polystyrene.
Shake aerosol cans prior to use. Stir bulk material prior to use and keep closed when not in use.
Mask clear plastic surfaces (windows, ports, etc.) before applying to prevent any possible fogging or cracking by the solvent carrier.

Further information

For more information or advice please contact us by telephone on +44 (0)20 8281 6370 or email us using our contact form.
CORR-EX products are supplied and supported by EnviroTech Europe Ltd.


CORR-EX®
Industrial Corrosion Protection And Control Solutions

EnviroTech Europe Ltd
100a High Street
Hampton
Middlesex
United Kingdom TW12 2ST

NATO Cage Code: U0H05
Company registered in UK No 4170693
VAT No GB765 682 977
© Copyright 2017 ALL RIGHTS RESERVED

Follow EnviroTech:
TERMS AND CONDITIONSCOOKIE POLICYSITE MAP


Telephone: +44 (0) 20 8281 6370
Website: www.corrosion-protect.com